Stainless steel roll plate to use paper is very simple, is to protect the stainless steel surface. Stainless steel coil in rolling, pickling, open, mirror, wire drawing, titanium plating and other processing processes, as well as storage and transportation these usually require the use of pad paper in the stainless steel coil between the finished product liner, protect the stainless steel coil bright and smooth surface, prevent friction between the stainless steel coil caused by scratches, bumps, creases, impressions and so on. Because many customers have high requirements for stainless steel surfaces, these defects are not allowed to appear on the stainless steel surface, at this time the protective effect of the paper on the stainless steel plate is obviously important.

It is precisely because of the high requirements of the surface of the stainless steel coil that the following points should be paid attention to when selecting and using the pad paper, the selection of excellent pad paper, the paper surface can not contain pulp, hard dust and other non-fiber impurities. Under normal circumstances, the quality of the paper recycled from the stainless steel coil is still OK, but it may be wrinkled during the recycling process, or the overlap of the tape connection, which may affect the stainless steel surface. Do not use wet pad paper, if the moisture content is too high, it may stick to the board, and it is difficult to take off for a long time. In the opening process, especially the sheet (below 0.4mm), be sure to pay attention to the flatness of the pad paper, any fold of the pad paper will bring indentation to the sheet. For stainless steel roll paper, it is better to be too wide than too narrow, and too narrow pad paper will have a great impact on winding after accumulation in thickness.